Looks great, congrats! Although I will say that the wood grain not being uniformly aligned (mostly visible on the white spaces) does bug me a little. But that’s just a small detail. What kind of wood did you use?
I know, same. I was being too hasty.
I actually can’t tell. I bought a job lot of veneer samples and they weren’t marked.
I’m guessing walnut & oak? Both are very nice looking.
Strong guesses, those are in the list of types on the posting but the individual pieces weren’t marked. I’m not much of a woods buff yet, I just went with what felt right.
I had two types per half, and used an even mix of grain and burl. Seemed like the best way to use the cuttings I have.
Agree on walnut but the lighter one is definitely ash imo
I’m basing the oak off a table I owned that was oak. Looked the same.
This looks fantastic!
Thanks! I’m happy with the result but I have ideas of what I’d do differently next time. …If there is one.
There absolutely should be a ‘next time’. You’ve done a really nice job there, and if you already have ideas for refinements and improvements (and assuming you actually enjoyed the process of making) you should certainly continue with it.
That’s very kind. I do plan to keep making things, but I’m slightly limited by the need for a worthwhile idea at times. Unless I know exactly why I’m doing things, I tend to run out of steam.
How do you sand and finish with the grain going in different directions?
Just keep your sandpaper clean. Going with the grain sanding is just to help hide if you drag a little, but there’s no requirement for it. Light hand, smooth strokes, change paper often, clean surface often
That’s what I did. It works okay. The idea was never perfection, this is my first foray into woodworking of any kind.
absolutely gorgeous! I love the gold corner accents.
Thanks! I found ones I liked even more, but shipping would have tripled the cost. Glad I found these ones.
